Philips VR620/07 Manual page 44

TIMER
DATE REP. PROG. START PDC END
21 MO-FR 01 20:00
________________________________
REP.pSELECT STOREpOK
40
a The following message appears on the screen: 'SELECT PROG.
VPS
b The programme number of the TV channel has not yet been assigned to
] 21:30
a The following message appears on the screen: 'PLUSCODE NUMBER
b The entered PlusCode number is incorrect. Correct your instructions or
b Check the time/date (see chapter 'Installing your video', section 'Setting the
a The
b A daily recording was entered for the wrong day. Daily programming can
5
The decoded data appears after confirmation. You can go back to
change the data. Select the corresponding input field using P or
Q . Change the data with ;qP , P r= or with the number
buttons 0-9 .
Switching on 'VPS/PDC' in the 'START' input field
Select the 'START' input field using
'VPS/PDC' (']' lights up). If you press
'VPS/PDC' off (']' goes out).
6
When all informations are correctly, confirm with
programming information is stored in a TIMER block.
7
Insert a cassette with an intact security tab (unprotected).
Using 'Tape List'
To save a recording in the 'Tape List' or to use a 'Tape List' cassette, enter
the cassette number using the number buttons
The cassette is being checked. You can find more information on the 'Tape
List' in the chapter 'Tape List'. If you don't use the Tape List, interrupt with
STOP h
8
Switch off with STANDBY/ON m .
The programmed recording will only function when the video
recorder is switched off with STANDBY/ON m .
If any of the TIMER blocks are in use, ' k ' will light up on the video
recorder display.
NR.'
the PlusCode number. Using the number buttons
control, select the corresponding programme number (programme name)
of the TV channel and confirm with
NOT VALID'
MENU
end with .
time and date').
following message appears
PROGRAMMING NOT POSSIBLE FOR WEEKEND'
only be used for recordings to be made from Monday to Friday.
.
0-9
on the remote
OK
.
on the screen: 'MO-FR
P
SELECT
. Using switch on
SELECT
again, you will switch
OK . The
0-9
on the remote control.
Programming a recording (TIMER)