Smoke Alarm; Operation; Testing - venture Sonic series Owner's Manual

PDF created with pdfFactory trial version
The signal is the LED flashing. RED/RED GREEN/GREEN with a beep
every 25-30 seconds. The EOL signal may be reset by pushing TEST/
RETEST button on the alarm. This will reset the EOL signal for a period of
72 hours for a total of up to 30 days. After 30 days the signal cannot be
reset and the alarm MUST be replaced. DO NOT DISCONNECT THE
ALARM UNTIL YOU HAVE A REPLACEMENT ALARM AVAILABLE TO
INSTALL.
WARNING!
!
LIMITATIONS OF CO AND GAS ALARMS
THIS ALARM WILL NOT WORK WITHOUT POWER
Some reasons for no alarm power are; a blown or missing fuse in 12V fuse
panel; broken wire; a faulty wire connection or circuit breaker; a discharged
battery; cut lead wires, or improper supply (+) or ground (-) connections.
Smoke Alarm—#3
Smoke alarms are required when propane is used in coach and open
flame cooking happens. Alarm is placed on ceiling between bedroom and
kitchen.
Energy to operate is supplied by a 9 volt battery inside of alarm.
Operation: The smoke alarm is in operation once the battery is
correctly connected. The LED will flash every minute to show the battery
is supplying power to the alarm. When production of combustion are
sensed, the unit sounds a loud alarm which continues until the air is
cleared.
Each smoke alarm has its own manual and is normally found in your
supplied materials with coach.

TESTING

Test the alarm by pushing the test button on the smoke alarm cover for at
least three seconds, until the alarm sounds. The alarm sounds if all
www.pdffactory.com
34