Table of Contents
Related Manuals for hivolt HAR12
Summary of Contents for hivolt HAR12
- Page 1 HAR12 12 Channel High Voltage Amplifier HAR2 2 Channel High Voltage Amplifier Operating Manual hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de...
-
Page 2: Table Of Contents
............................ 13 NTERNAL ONNECTORS ............................13 MBIENT CONDITIONS .......................... 14 ECHANICAL PECIFICATIONS DECLARATION OF CONFORMITY ........................15 hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... -
Page 3: Warnings
Fuses have to be replaced by types as rated on the nameplate on the rear of the unit. Personal safety must be given the highest priority ! hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... - Page 4 Sollte ein Ersatz der Netzsicherungen erforderlich sein, so ist sicherzustellen, dass nur Sicherungen der angegebenen Nennstromstärke und Nennspannung als Ersatz verwendet werden. Der Personensicherheit ist höchste Priorität einzuräumen! hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99...
-
Page 5: Overview
3 Description The high voltage amplifier HAR12 is a 3U high 19" rack-mountable unit. Up to twelve independent channels provide output voltages in the range of –500V to +500V at a load current of ±2mA each. -
Page 6: Block Diagram
I NHIB -540V I-MON 10R0 49R9 OFFSET V-MON INHI B INHIB The block diagram shows one amplifier channel. hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... -
Page 7: Control Voltage Input
(coaxial cable). They are not designed to drive terminated cables (50/75 Ω), and they should not be short circuited during normal operation. Load impedance 4 kΩ. hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... -
Page 8: Inhibit
This occurs if the final value of the desired output voltage can not be reached periodically. No damage to the amplifier modules will result from the different conditions mentioned. hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... -
Page 9: Installation And Operation
Do not mate or unmate the output connector unless the device is switched off! 4.5 Ventilation Requirements The HAR12 Amplifier Subrack may be used in rack mounted or bench top applications. In either case, sufficient space must be allowed for cooling air to reach the ventilation inputs on the front panels and for the fan exhaust air to exit from the rear of the unit. -
Page 10: Rack Mounting Har12
4.6 Rack Mounting HAR12 The HAR12 Amplifier Subrack is designed to fit in a standard 19" equipment rack. Use the rack mount brackets at both sides of the front panel to install the unit into a 19" rack. 4.7 Wall Mounting HAR2-W... -
Page 11: Troubleshooting
HAR2, HAR2-W Parameter Conditions Supply voltage 22.8 – 25.2 Vdc Input current =24Vdc, full load 0.6 Adc hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... - Page 12 = 100 pF ca. 2.5 ms Signal ground and high voltage ground are connected to chassis ground / protective earth. hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99...
-
Page 13: External Connectors
BNC (HAR12, HAR12A) Outputs: SHV (HAR12S, HAR2, HAR2-W) Power line: IEC320-1 (HAR12, HAR12A, HAR12S) Earth: Bolt M4 (HAR12, HAR12A, HAR12S) Power supply: 2 pole Combicon Plug (796634-2) (HAR2, HAR2-W) 5.2 Internal Connectors Internal connectors for HA05B2 plug-in modules (DIN41612, Type F) Pins... -
Page 14: Mechanical Specifications
Width (HAR2/HAR2-W) 141/177 Height (HAR2/HAR2-W) 139/134 Weight © hivolt.de GmbH&Co. KG and WME Power Systems GmbH, Hamburg, Germany 10/2016 hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99... -
Page 15: Declaration Of Conformity
Classification: Group 1, Class B Manufacturer: WME Power Systems GmbH Oehleckerring 40 D-22419 Hamburg 2016-10-04 Wulf Müller Managing Director hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de... - Page 16 Klassifizierung: Gruppe 1, Klasse B Hersteller: WME Power Systems GmbH Oehleckerring 40 D-22419 Hamburg 2016-10-04 Wulf Müller Geschäftsführer hivolt.de GmbH & Co. KG Oehleckerring 40 D-22419 Hamburg +49 40 53 71 22 80 +49 40 53 71 22 99 info@hivolt.de http://www.hivolt.de...
Need help?
Do you have a question about the HAR12 and is the answer not in the manual?
Questions and answers