HYOSUNG Aquila GT250 Ej Service Manual page 45

4-1-27 EI SYSTEM DIAGNOSIS
SELF-DIAGNOSIS RESET PRO-
CEDURE
A. LCD (DISPLAY) PANEL
After repairing the trouble, refer to page 30 [4-1-
13], move to the malfunction code mode .
If the clock screen
the malfunction codes are cleared.
Disconnect the special tool from the dealer mode
coupler at the wiring harness.
B. "FI" CHECK LAMP
Repair the trouble.
Turn the ignition switch to the "OFF" position and
return to the "ON" position, and then wait for 10
seconds.
Repeat the above procedure 30 times.
In this case, the malfunction codes are cleared.
A. "FI" CHECK LAMP
Repair the trouble.
Turn the ignition switch to the "OFF" position and
return to the "ON" position, and then wait for 10
seconds.
Repeat the above procedure 30 times.
In this case, the malfunction codes are cleared.
indicates the "noEr" letters,
44
KEY
KEY