Advertisement
XV-D9000
Removing the turntable and spindle motor assembly
(See Fig.8~9)
* Remove the traverse mechanism unit.
* Solder the flexible ground point on the optical pickup.
(See Fig.6)
* Remove the mechanism control board.
1. Remove the flexible harness from the feed motor
connector on the spindle motor board assembly.
2. Remove the three screws D attaching the spindle motor
from the bottom of the traverse chassis.
Removing the feed motor unit (See Fig.9)
* Remove the traverse mechanism unit.
* Remove the mechanism control board.
1. Remove the FPC from the feed motor connector
on the turntable spindle motor board.
2. Remove the two screws E attaching the feed motor unit.
Removing the optical pickup unit (See Fig.9)
* Remove the traverse mechanism unit.
* Remove the mechanism control board.
* Remove the feed motor unit.
1. Remove the screw F attaching the guide shaft holder at b,
then simultaneously remove the guide shaft at B and the
optical pickup unit. While doing so, slide the unit
horizontally away from the guide shaft at a.
1-16
Traverse chassis
F
Guide shaft b
E
E
Feed motor assembly
Flexible harness
Feed motor connector
D
Fig.8
Traverse mechanism unit
Pick-up assembly
Guide
shaft a
Turn table/spindle motor unit
Fig.9
Advertisement
