Configuring Ipv6 Static Multicast Mac Address Entries - HPE FlexFabric 5930 Series Ip Multicast Configuration Manual

Step
Enter system view.
1.
Enter interface view.
2.
Configure the interface as
3.
an IPv6 multicast
forwarding boundary for an
IPv6 multicast group range.

Configuring IPv6 static multicast MAC address entries

In Layer-2 multicast, a Layer-2 IPv6 multicast protocol (such as MLD snooping) can dynamically add
IPv6 multicast MAC address entries. Or, you can manually configure IPv6 multicast MAC address
entries.
TIP:
• You do not need to enable IPv6 multicast routing before this configuration.
• The IPv6 multicast MAC address that can be configured in a MAC address entry must be
unused. A multicast MAC address is the MAC address in which the least significant bit of the
most significant octet is 1.
You can configure IPv6 static multicast MAC address entries on the specified interfaces in system
view, or on the current interface in interface view.
To configure an IPv6 static multicast MAC address entry in system view:
Step
Enter system view.
1.
Configure a static multicast
2.
MAC address entry.
To configure an IPv6 static multicast MAC address entry in interface view:
Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface/Layer 2 aggregate
interface view.
Configure a static multicast
3.
MAC address entry.
Command
system-view
interface interface-type
interface-number
ipv6 multicast boundary
{ ipv6-group-address prefix-length |
scope { scope-id | admin-local |
global | organization-local |
site-local } }
Command
system-view
mac-address multicast
mac-address interface
interface-list vlan vlan-id
Command
system-view
interface interface-type
interface-number
mac-address multicast
mac-address vlan vlan-id
265
Remarks
N/A
N/A
By default, the interface is not
configured as an IPv6 multicast
forwarding boundary for any
group range.
Remarks
N/A
By default, static multicast MAC
address entries do not exist.
Remarks
N/A
N/A
By default, static multicast MAC
address entries do not exist.