Configuring Parameters For Mld Messages; Configuration Prerequisites; Configuring Source Ipv6 Addresses For Mld Messages - HPE FlexFabric 5930 Series Ip Multicast Configuration Manual

Configuring parameters for MLD general queries and responses in a VLAN
Step
Enter system view.
1.
Enter VLAN view.
2.
Set the MLD general query
3.
interval for the VLAN.
Set the maximum response
4.
time for MLD general queries
in the VLAN.

Configuring parameters for MLD messages

This section describes how to configure parameters for MLD messages.

Configuration prerequisites

Before you configure parameters for MLD messages in a VLAN, complete the following tasks:
•
Enable MLD snooping for the VLAN.
•
Determine the source IPv6 address of MLD general queries.
•
Determine the source IPv6 address of MLD multicast-address-specific queries.
•
Determine the source IPv6 address of MLD reports.
•
Determine the source IPv6 address of MLD done messages.
•
Determine the 802.1p priority of MLD messages.

Configuring source IPv6 addresses for MLD messages

You can change the source IPv6 address of MLD queries sent by an MLD snooping querier. This
configuration might affect MLD querier election within the subnet.
You can also change the source IPv6 address of MLD reports or leave messages sent by a simulated
member host.
To configure the source IP addresses for MLD messages in a VLAN:
Step
Enter system view.
1.
Enter VLAN view.
2.
Configure the source IPv6
3.
address for MLD general
queries.
Command
system-view
vlan vlan-id
mld-snooping query-interval
interval
mld-snooping
max-response-time interval
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip ipv6-address
228
Remarks
N/A
N/A
The default setting is 125
seconds.
The default setting is 10 seconds.
Remarks
N/A
N/A
The default setting is the IPv6
link-local address of the current
VLAN interface. If the current
VLAN interface does not have an
IPv6 link-local address, the
source IPv6 address is
FE80::02FF:FFFF:FE00:0001.