Led Light; Notes On Cleaning; Ec Declaration Of Conformity - Bresser 9110500 Operating Instructions Manual

Using your metal detector:
Before powering on the device position the metal detector so the search coil is away from any metal
objects. Then turn the unit on by moving the toggle on the device away from you. You will see a green
LED light showing the power is turned on. Your unit is self-calibrated and needs no further adjustment.
Your metal detector is ready to be used in the most sensitive detection setting.
To search for metal objects, swing the metal detector back and forth slowly while keeping the search
coil level and approx. 2 cm above the ground. When your metal detector locates a metal object it will
start to emit a tone. The more solid and louder the tone, the stronger the signal, which indicates how
close the object is to the coil. Your unit also has an LED light that will illuminate when the signal strength
is strong. By using both the LED light and the tone you will be able to discover many amazing things
just below ground.

LED light

Power the LED light unit on by pressing the light switch. With the light on, you will be able to work your
way into darker places to find your treasures. The light can also be handy early in the morning and into
the early evening.

Notes on Cleaning

• Before cleaning the device, disconnect it from the power supply (remove batteries)!
• Only use a dry cloth to clean the exterior of the device. To avoid damaging the electronics, do not
use any cleaning fluid.
• Protect the device from dust and moisture.
• Remove the batteries from the unit if it is not used for a longer time.

EC Declaration of Conformity

Bresser GmbH has issued a 'Declaration of Conformity' in accordance with applicable
guidelines and corresponding standards. This can be viewed any time upon request.
10
Correct
Correct
Wrong
Wrong