Adjustments; Oven Door; Burner Flame Adjustment - Garland G56PT Installation And Operator's Manual

ADJUSTMENTS

NOTE: Each oven has been factory tested and adjusted
prior to shipment . It may be necessary to further adjust
the oven as part of a proper installation . Such adjustments
are the responsibility of the installer . Adjustments are not
considered defects in material or workmanship, and they are
not covered under the original equipment warranty .

Oven Door

The "AIR DECK" oven door has adjustability as a design
feature . Although it is factory set, the tension can be adjusted
to suit the operator's preference . In addition, after a long
period of hard use, the tension can be readjusted as required .
To adjust door tension it is necessary to remove left and
right front corners of unit by the two sheet metal screws .
This exposes the door hinge and spring assembly . The spring
hook passed through a bracket . A 1/4" x 20 nut is on the
spring hook forward of the bracket . If it is available, use a
7/16" deep socket and ratchet to turn the nut clockwise to
increase spring tension or counter-clockwise to relieve spring
tension . Make sure to adjust both sides equally .
The oven door is properly adjusted if the door remains fully
open and if the spring tension carries the door to the full
closed position from the half-closed position . Replace the
corner and fasten with screws .
Page 12

Burner flame Adjustment

The "AIR DECK" utilizes a power burner assembly as a heat
source . To ensure peak efficiency, a proper air-fuel mixture is
necessary . There is an inspection port (window) on the power
burner . There is an air shutter located on the blower motor
that should be adjusted to provide a good blue flame with
no yellow tips .
Below is a drawing illustrating the proper way to check the
burner blower air shutter adjustment .
NATURAL
PROPANE
7/8"
1/2"
Part # 1382670 (12/07)