Philips DV900VHS Owner's Manual page 37

4
Use the Number buttons (1-8) to select a slot in which to
store the timer recording. There are eight slots. Numbers for
open slots will flash on the screen.
NOTE: If you enter a number for a slot that has already been used to store
a timer recording, PREVIOUSLY SET PROGRAM will appear on the screen
briefly. Information about the program in that slot will appear on the screen.
If this happens, press the DISPLAY/STATUS/EXIT button, then select another
number.
5
Use the Number buttons to enter the TV channel you want
to record.
Cable Users, enter channel numbers as a two-digit number for the
quickest results. For example, to select channel 6, press 0,6. If you
only press the Number 6 button, channel 6 will be selected after a
brief delay. There also may be a brief delay when you select channels
If you want to select channels 100 and above, enter
10, 11, and 12.
channel numbers as a three-digit number. For example, to select
channel 117, press 1, 1, 7.
Antenna Users, enter channel numbers as a two-digit number for
the quickest results. For example, to select channel 5, press 0,5. If
you only press the Number 5 button, channel 5 will be selected
after a brief delay. You may only select channels 2-69.
If you are recording from line input, press 0,0 to select AV REAR.
If you are using a Cable Box/DBS, select the Cable Box/DBS out-
put channel (03 or 04). Set the Cable Box/DBS to the channel you
want to record. Leave the Cable Box/DBS on for the timer
recording. Details are on page 10.
6
Press two Number buttons for the hour you want the
recording to begin. Press two Number buttons for the
minute you want the recording to begin. Press 1 for AM or
2 for PM. For example, for 9:30 PM, press 09, 30, 2.
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON – – : – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
7
Follow the instructions in step 6 to enter the recording's
stop time. (AM or PM will be set automatically.)
ONE TIME PROGRAM
PROGRAM 1
CHANNEL 10
TIME ON 09:30 PM
TIME OFF – – : – –
TO CORRECT PUSH CLEAR
TO END PUSH EXIT
Instructions continue on page 38.
Timer Recording (cont'd) 37
4-7
POWER
DVD/VCR
VCR/TV
OUTPUT
DVD
REW
1 2
4 5
7 8
SPEED
0
DISPLAY
SEARCH MODE
TIME SEARCH STATUS/EXIT
SETUP MODE
Helpful Hints
• Entries that do not match the
DVD/VCR's clock or calendar will
cause a question mark to appear
on the screen.
• If you are recording from line input,
connect the audio and video cables
to the AUDIO IN and VIDEO IN
jacks on the back of the DVD/VCR.
(Please see illustration on page 40.)
TIMER SET
MEMORY
VCR
PLAY
F.FWD
STOP
PAUSE
3
6
SLOW
9
A B
+10
CLEAR
REPEAT
MENU TITLE
ENTER RETURN
AUDIO SUB TITLE ANGLE