Learning; Tips On Learning - Philips SRU8010 Owner's Manual

Learning

Tips On Learning

a. Some functions from some types of remotes might not
be able to be learned.
b. No functions may be learned under the HOME,
MODE, FAVORITE, HIS, or HERS (hard) keys.
c. Use fresh batteries for both the SRU8010 remote and
your Original Remote.
d. Keep at least three feet away from incandescent or low-
energy lights when learning.
e. Place the original remote end-to-end with the SRU8010
remote so the IR transmitter (at the top) on your original
remote points at the IR learning device on the bottom of
the SRU8010 remote.
f. Keep the distance between the two remotes to
approximately 1 inch.
g. Line up the remotes and then press the key you want to
learn. To get the correct range, press the key on the remote
you are learning and you will see a "red halo" around the
transmit icon at the bottom left of the screen starts to
flicker. The best range for learning is when it flickers most
rapidly. Move the position of the 2 remotes to achieve this.
Do not change this "best distance" between the two
remotes until you have learned all the required keys.
h. When Learning, you should normally not release the key
being learned until the display prompts you to do so.
However, some keys might be learned multiple times if
you do this. If this happens just "tap" the key you want to
learn, rather than press and hold it. For example, keys that
you normally hold down for a while (like volume up or
down) will likely require a long press when learning. Keys
that you normally give a quick press (like the numbers,
and channel up/down) will likely require a quick press
when learning. If after learning say the channel up key,
you find that it changes multiple channels when pressed
once, try relearning it with a short keypress.
i. If learning the first or second keys results in continuous
errors then try the following:
1. Check the IR transmitters/sensors are correctly aligned
between the two remotes.
16