Intel BS-E098 User Manual page 55

BIOS Setup
Navigation Key
<←> and <→>
<↑> and <↓>
<Enter>
<F2>
<F3>
<F4>
<Esc>
BIOS Messages
This section describes the alert messages generated by the board's BIOS. These
messages would be shown on the monitor when certain recoverable errors/events
occur during the POST stage. The table bellow gives an explanation of the BIOS alert
messages:
BIOS Message
A first boot or NVRAM
reset condition has been
detected.
The CMOS defaults
were loaded.
The CMOS battery is
bad or has been recently
replaced.
BS-E098 SERIES USER MANUAL
Select a different menu screen (move the cursor from the
selected menu to the left or right).
Select a different item (move the cursor from the
selected item upwards or downwards)
Execute the command or select the sub-menu.
Load the previous configuration values.
Load the default configuration values.
Save the current values and exit the BIOS setup menu.
Close the sub-menu.
Trigger the confirmation to exit BIOS setup menu.
BIOS has been updated or the battery was replaced.
Default values have been loaded after the BIOS was
updated or the battery was replaced.
The battery may be losing power and users should
replace the battery immediately. Also, this message is
displayed once the new battery is replaced.
Chapter 5 BIOS Setup
Description
Explanation
Page: 5-5