Philips TYPE VR 175 Operating Instructions Manual page 2

&
Programming with 'VIDEOPlus+'
All the information required for a programming is contained encoded in the VIDEOPlus+ code.
1 Switch on the TV set.
TIMER k
2
Press the button on the remote control.
3 Please enter the VIDEOPlus+ -code (up to 9 digits) printed in your TV guide next to the start time
of a TV programme.
If you make a mistake, clear with the
4 If you want to programme at daily or weekly intervals, press the
(daily intervals) or 'W-WEEKLY' (weekly intervals) appears in the display. The 'daily intervals'
function can only be used for recordings to be made from Mondays to Fridays inclusive.
5 Confirm the entries with the OK button . The resultant data appears on the TV screen.
Note: If you use VIDEOPlus+ for the first time for this TV channel, the 'SELECT PROG' line
appears when you confirm the VIDEOPlus+ code. Select and confirm the programme number
for this particular TV programme.
* If you wish to set a later end time for a recording, press the
P q
each press on the button you add 15 minutes to the time.
* If e.g.: '20:00' appears in the display, please set the clock.
OK
6 Finally, press the button. Programming is now complete.
The data has been stored in a TIMER block.
7 Make sure that a cassette without erase protection has been loaded. Switch to standby with the
STANDBY m
button.
A programmed recording will only function when the video recorder is switched to standby with
STANDBY m
the button.
CLEAR (CL)
button.
SELECT button until 'D-DAILY'
P q
button at step
5
How to programme a recording manually
1 Switch on the TV set. Press the
2 Select a free TIMER block. Press the
TIMER k
3 With the
number), 'START' (start time) and 'END' (stop time).
You can enter or adjust data. Confirm each entry with the
You can select between 'D' (daily intervals) or 'W' (weekly intervals) at step 'DATE' with the
. With
SELECT button.
4 Finally, press the
5 Make sure that a cassette without erase protection has been loaded. Switch to standby with
STANDBY m
the
A programmed recording will only function when the video recorder is switched to standby
STANDBY m
with the
Note:
* Clear a TIMER-block: At step
CLEAR (CL)
button.
* If e.g.: '20:00' appears in the display, the clock must be set.
TIMER k
button twice.
TIMER k
button.
DATE PROG START END
01 01 20:00 21:30
------------------------
gTIMER CLEAR gCL
NEXT
-/+ 0-9 D/WgSELECT OK
button you choose between the entries 'DATE' (date), 'PROG' (programme
TIMER k
OK button. Programming has now been completed.
button.
button.
1 select the TIMER block you want to clear. Press the
button.