Function Introduction For Combination Buttons - Gree GWH24ACD-K3NNA1A Service Manual

Service Manual
TEMP button
7.
Press this button, you can see indoor set temperature, indoor ambient temperature on indoor unit's display. The setting
on remote controller is selected circularly as below:
8. TURBO button
Press this button to activate / deactivate the Turbo function.
9. I FEEL button
Press this button to start I FEEL function and " " will be displayed on the remote controller. After this function is set, the remote
controller will send the detected ambient temperature to the controller and the unit will automatically adjust the indoor temperature
according to the detected temperature. Press this button again to close I FEEL function and " " will disappear.
10. Timer button
When unit is on, press this button to set Timer Off. OFF and HOUR icon will be blinking. Within 5s, press ▲ or ▼ button to adjust the
time for Timer Off. Pressing ▲ or ▼ button once will increase or decrease the time by 0.5h. Hold ▲ or ▼ button for 2s, time will change
quickly. Release the button after your required set time is reached. Then press TIMER button to confirm it. OFF and HOUR icon will
stop blinking.
When unit is off, press this button to set Timer On. ON and HOUR icon will be blinking. Within 5s, press ▲ or ▼ button to adjust the
time for Timer On. Pressing ▲ or ▼ button once will increase or decrease the time by 0.5h. Hold ▲ or ▼ button for 2s, time will
change quickly. Release the button after your required set time is reached. Then press TIMER button to confirm it. ON and HOUR icon
will stop blinking.
Cancel Timer On/Off: If Timer function is set up, press TIMER button once to cancel this function.
Note:
Range of time setting is: 0.5~24h
The interval between two motions can't exceed 5s, otherwise the remote controller
will exit setting status.
11. X-FAN button (NOTE:X-FAN is the alternative expression of BLOW for the purpose of understanding.)
12. LIGHT button
Turn on the display's light and press this button again to turn off the display's
NOTICE:
As for the detailed content of remote controller, please refer to QR code on the cover.

Function introduction for combination buttons

Combination of " " and " " buttons: About lock
▲
Press " " and " ▲ " buttons simultaneously 3s to lock or unlock the keypad. If the remote
pressing any button, blinks three times.
Combination of "MODE" and " " buttons:
At unit OFF, press "MODE" and "
Combination of "TEMP" and "TIMER" buttons: About Energy-saving Function
Press "TEMP" and "TIMER" simultaneously in COOL mode to start e nergy-saving function.
"SE". Repeat the operation to quit the function.
Technical Information
Combination of "TEMP" and "TIMER" buttons: About 8
Press "TEMP" and "TIMER" simultaneously in HEAT mode to start 8
no display
About switch between Fahrenheit and centigrade
" buttons simultaneously to switch between
light.
controller is locked,
and .
Nixie tube on the remote controller displays
Heating Function
Heating Function Nixie tube on the remote controller displays "
is displayed. In this case,
"
13