Extra Possibilities; Adding A Function To The Remote Control; Restoring The Original Functions Of Your Remote Control; Troubleshooting - Philips SRU 510/86 Instructions For Use Manual

SRU510_86_v6.qxd 26-04-2005 14:11 Pagina 8
Instructions for use

4. Extra possibilities

Adding a function to the remote control

If you want to add a function to the SRU510, you can contact the
Philips service line for Universal Remote Control to ask for the 5-figure code
for the extra function.
Restoring the original functions of your remote
control
1
Keep keys 1 and 6 on the SRU510
pressed simultaneously for three seconds,
until the LED flashes twice and then remains
lit.
2
Press keys 9, 8 and 1, in that order
– The LED flashes twice.
All original functions have now been restored
and any extra functions have been deleted.

5. Troubleshooting

• Problem
– Solution
• The LED blinks four times after every key press.
– The remote control is indicating that its batteries are running low. Replace the old
batteries with two new 1.5 Volt, AAA batteries.
• The TV does not respond and the LED does not flash when you press a
key.
– Replace the old batteries with two new 1.5 Volt, AAA batteries.
• The TV does not respond but the LED does flash when a key is pressed.
– Point the SRU510 at the device and make sure that there are no
obstructions between the SRU510 and the device.
• The SRU510 does not respond properly to commands.
– Maybe you are using the wrong code. Try programming the RU510 again
using another code, which is mentioned under the brand of your device, or
reset for automatic search to find the right code.
If the TV still does not respond, call our helpline.
• The Teletext keys do not work.
– Find out whether your TV is equipped with Teletext.
• You have difficulties operating all of the functions on your device.
– Maybe the SRU510 has to be adapted to the model of the device.
Call our helpline for details.
• Your brand of device is not in the code list.
– Try to set the SRU510 automatically.
See 'Automatically setting the remote control'.
• None of the codes works during manual setting of the remote control.
– If that is the case, follow the instructions under
'Automatically setting the remote control'.
8