Setting Up The Massage Chair - Brookstone Rock & Recline User Manual

SETTING UP THE MASSAGE CHAIR

Unpacking and positioning the massage chair
1. Remove the top portion of the carton.
2. Lift the chair out of the bottom portion of the carton and place in desired
location.
• To avoid injury and minimize the chance of dropping the chair, it is recom-
mended that two people lift the chair.
• When positioning the chair, allow sufficient space around the chair for
reclining and for raising the leg rest.
• Place on a dry, level surface.
• To avoid damage to the floor and to reduce noise, put a rug or other floor
protection under the massage chair.
• To avoid signal interference, place the chair a minimum of four feet away
from audio/visual equipment, such as televisions and radios.
• Do not place in direct sunlight or in places of high temperature.
Warning:
Do not put the power cord under the chair.
8
Moving the massage chair
• As illustrated, push the backrest down-
wards and tilt chair on to its wheels at a
45 o angle.
• Slowly push and maneuver the massage
chair to desired location. Lower massage
chair slowly and smoothly until it is fully
flat on the ground.
• Do not move the massage chair when someone is sitting in it. This will cause
the chair to tip over, resulting in accident and injuries.
• Moving the massage chair may cause damage to floors. Floor protection,
such as rugs or carpet, is recommended.
• Do not drop or suddenly let go of the chair when moving, as it may damage
the chair.
• To avoid injury and minimize the chance of dropping the chair, it is recom-
mended that two people move the chair.
• Do not move by pulling on the cord.
Caution
9