Philips SRU 5086 Instructions For Use Manual page 6

Instructions for use
6
Check if you can operate all functions on your TV with the SRU 5060.
• If this is not the case, you can redo the automatic setting.
The SRU 5060 will then search for a code that works better.
– After the SRU 5060 has run through all the known codes,
the search will stop automatically and the Standby key will stop flashing.
– Automatic programming of a TV takes a maximum of 5 minutes.
For DVD, CD,VCR, AMP and STB this time is 2 minutes.
Manually setting the remote control
Example of TV:
1
Turn on the TV manually or use the original remote control.
Tune in to channel 1.
2
Look up the brand of your TV in the
code list at the back of this manual.
One or more four-figure codes are shown for
each brand. Note the first code.
Be careful! There are separate tables for TV,
video, DVD, etc.
On our website www.philips.com/urc you can directly select your device
typenumber to find the tight code.
Make sure you use the codes from the correct table.
3
Press the SELECT key to select TV.
Press the key until the Standby key lights up.
4
Keep keys 1 and 3 pressed simultaneously
for three seconds until the Standby key
flashes twice and then remains lit.
5
Then enter the code noted in step 2 using the digital keys.
– The Standby key will now flash twice.
If the key flashes once for an extended period, the code has not been
entered properly or the wrong code has been entered.
Start again from step 2.
6
Point the SRU 5060 at the TV and check that it responds as it should.
– If the TV responds to all of the key commands, the SRU 5060 is ready
for use. Do not forget to note your code.
• If the device does not respond at all, or not to all of the
key commands, start again from step 2 and try the next code
from the list.
6