Installing the base cover
1
Align the base cover with the screw holders on the computer.
2
Press the edges of the cover until it clicks into place.
3
Tighten the M2x5 screws to secure the base cover to the computer.
4
Follow the procedure in
Battery
Removing the battery
NOTE:
92 WHr battery requires the use of a M.2 card and a 68Whr battery can use either a M.2 or 7mm SATA drive.
1
Follow the procedure in
2
Remove the
base
cover.
3
To remove the battery:
a
Disconnect the battery cable from the connector on the system board [1].
b Loosen the M2x5 screws that secure the battery to the computer [2].
c
Lift the battery away from the computer [3].
NOTE:
A 4-cell 68Whr battery has only 1 screw.
After working inside your
computer.
Before working inside your
computer.
Removing and installing components
11