Advertisement
DRY OPERATION
8
For dehumidif cation, a moderate cooling performance is controlled automatically.
MODE
1. Press
: Select Dry
2. Press
: Set the desired temperature.
9
Hi-POWER OPERATION
To automatically control room temperature and airf ow for faster cooling operation
(except in DRY and FAN ONLY mode)
Press
: Start and stop the operation.
Hi POWER
POWER-SELECTION OPERATION
10
This function is used when its circuit breaker is shared with other electrical
appliances. It limits the maximum current/power consumption to 100%, 75%
or 50%. The lower the percentage, the higher the saving and also the longer
the compressor lifetime.
Press
: Select
(for 100%),
POWER-SEL
• When the level is selected, PWR-SEL level f ashes on LCD display for 3 seconds.
In case of 75% and 50% level, number "75" or "50" also f ashes for 2 seconds.
• Due to the reason that POWER SELECT FUNCTION limits the maximum
current, inadequate cooling capacity may occur.
11
TEMPORARY OPERATION
In case of the misplaced or discharged remote control
• Pressing the RESET button, the unit can start or stop without using
the remote control.
• Operation mode is set on AUTOMATIC operation, preset temperature is
25°C
and fan operation is
automatic s peed.
TIMER OPERATION
12
Set the timer when the air conditioner is operating.
Setting the ON Timer
Press
: Set the desired
1
ON timer.
2
Press
: Set the timer.
3
Press
: Cancel the timer.
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
Setting Daily Timer
1
Press
: Set the ON timer.
2
: Set the OFF timer. 4
Press
• During the daily timer is activating, both arrows ( , ) are indicated.
Note:
• Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
• The setting will be saved for the next same operation.
PRESET OPERATION
13
Set your preferred operation for future use. The setting will be memorized by the
unit for future operation (except airf ow direction).
1. Select your preferred operation.
2 . Press and hold
The
P
mark displays.
3. Press
: Operate the preset operation.
.
(for 75%),
(for 50%)
Setting the OFF Timer
Press
: Set the desired OFF
timer.
Press
: Set the timer.
Press
: Cancel the timer.
3
Press
.
Press
: button during the
( or ) mark f ashing.
for 3 seconds to memorize the setting.
14
AUTO RESTART OPERATION
To automatically restart the air conditioner after the power failure (Power of the
unit must be on.)
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds to set
the operation. (3 beep sound and OPERATION lamp blink 5 time/sec for
5 seconds)
2. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (3 beep sound but OPERATION lamp does not
blink)
• In case of ON timer or OFF timer are set, AUTO RESTART
OPERATION does not activate.
15
QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
QUIET
Press
: Start and stop the operation.
Note: Under certain conditions, QUIET operation may not provide adequate
cooling due to low sound features.
16
COMFORT SLEEP OPERATION
For comfortable sleep, automatically control air f ow and automatically turn OFF.
Press
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
Note: The cooling operation, the set temperature will increase automatically
1 degree/hour for 2 hours (maximum 2 degrees increase).
MAINTENANCE
17
Firstly, turn off the circuit breaker.
Indoor Unit and Remote Control
• Clean the indoor unit and the remote control with a wet cloth when needed.
• No benzine, thinner, polishing powder or chemically-treated duster.
Air filters
Clean every 2 weeks.
1. Open the air inlet grille.
2. Remove the air filters.
3. Vacuum or wash and then dry them.
4. Reinstall the air filters and close the air inlet grille.
SELF CLEANING OPERATION (COOL AND
18
DRY OPERATION ONLY)
To protect bad smell caused by the humidity in the indoor unit.
1. If the
the fan will continue to run for other 30 minutes, then it will turn off
automatically. This will reduce the moisture in the indoor unit.
2. To stop the unit immediately, press the
30 seconds.
OPERATION AND PERFORMANCE
19
1. Three-minute protection feature: To prevent the unit from being activated
for 3 minutes when suddenly restarted or switched to ON.
2. Some minor cracking sound may occur when unit operating. This is
normal because the cracking sound may be caused by expansion/
contraction of plastic.
Air conditioner operating conditions
Temp.
Operation
Cooling
Dry
2
button is pressed once during "Cool" or "Dry" mode,
more 2 times within
Outdoor Temperature
Room Temperature
- 10°C ~ 46°C
- 10°C ~ 46°C
21°C ~ 32°C
17°C ~ 32°C
Advertisement
