Table of Contents
Advertisement
I Using Wireless Remote Controller
ON
OFF
SET
CANCEL
PLASMA
❉ Some remote controllers may not support above functions according to the production
date of wired/wireless remote controllers. As it has no concern with customer's use,
use the remote controller available for the address setting during installation.
1. Address setting mode
1) Keep pressing upper left side key continuously and press
RESET button once. Now the system is ready for address
setting.
2) Set the Indoor unit address using the temperature
controller buttons.
Allowed Range : 00-FF
Ex)
3
Address
check
A
Address
setting
3) After setting the address, press ON/OFF key once
towards Indoor unit.
4) The Indoor unit shows the set address and it means
completion of address setting process. (The address
displaying time and its way can depend upon the type of
Indoor unit )
2. Address check mode
1) Keep pressing upper right side key continuously and
press RESET button once. Now the system is ready for
address checking.
2) Press ON/OFF key once toward the Indoor unit which
shows set address on the display.(The address
displaying time and its way depends upon the type of
Indoor unit )
3) Reset the remote controller to use it for normal operation
mode.
Group No.
Indoor unit No.
Owner's & Installation Manual 15
Product setting
Advertisement
Table of Contents
