Onboard Leds And Buttons - Gigabyte X399 AORUS Gaming 7 User Manual

1-8

Onboard LEDs and Buttons

Status LEDs
The status LEDs show whether the CPU, graphics card, memory, and operating system are working properly
after system power-on. If the CPU/VGA/DRAM LED is on, that means the corresponding device is not working
normally; if the BOOT LED is on, that means you haven't entered the operating system yet.
CPU
VGA
Quick Buttons
This motherboard has 3 quick buttons: power button, reset button and clear CMOS button. The power button
and reset button allow users to quickly turn on/off or reset the computer in an open-case environment when
they want to change hardware components or conduct hardware testing. Use this button to clear the BIOS
configuration and reset the CMOS values to factory defaults when needed.
PW_SW
RST_SW
CMOS_SW
• Always turn off your computer and unplug the power cord from the power outlet before using
the clear CMOS button.
• Do not use the clear CMOS button when the system is on, or the system may shutdown and
data loss or damage may occur.
• After system restart, go to BIOS Setup to load factory defaults (select Load Optimized Defaults) or
manually configure the BIOS settings (refer to Chapter 2, "BIOS Setup," for BIOS configurations).
DRAM
CPU: CPU status LED
VGA: Graphics card status LED
DRAM: Memory status LED
BOOT: Operating system status LED
BOOT
PW_SW: Power Button
RST_SW: Reset Button
CMOS_SW: Clear CMOS Button
- 23 - Hardware Installation