Advertisement
Adjusting the Rear Guide
The Reliance printer is shipped to you already set up for the paper width you ordered. If you
need to change this paper width, loosen the screws indicated in the figure below and push the
guides together to the desired width.
For 70mm paper, align the arrows on the paper guides to the raised ribs on the printer frame as
shown, tighten screws:
For 60mm paper, push the paper guides together completely as shown, tighten screws:
For 80mm paper, push the paper guides apart as shown below, tighten screws:
FIgure 10
Figure 11
Figure 12
Figure 13
11
Advertisement
