Item reference numbers are used in the overview illustration and
refer to the numbers used in the key in the product overview sec-
tion.
This symbol is intended to draw special attention to certain points
when handling the product.
1.3 Product-dependent symbols
1.3.1 Symbols on the product
The following symbols are used on the product:
Drilling without hammering
Drilling with hammering action (hammer drilling)
Protection class II (double-insulated)
Rated speed under no load
Revolutions per minute
1.4 Product information
Hilti products are designed for professional use and may be operated, ser-
viced and maintained only by trained, authorized personnel. This personnel
must be informed of any particular hazards that may be encountered. The
product described and its ancillary equipment may present hazards when
used incorrectly by untrained personnel or when used not as directed.
The type designation and serial number are printed on the type identification
plate.
▶ Write down the serial number in the table below. You will be required to
state the product details when contacting Hilti Service or your local Hilti
organization to enquire about the product.
Product information
Drill/driver
Generation
Serial no.
2 Safety
2.1 General power tool safety warnings
WARNING
Read all safety warnings and all instructions. Failure to follow the warnings
and instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
Printed: 01.02.2017 | Doc-Nr: PUB / 5329076 / 000 / 00
SF 6H-A22
01
English
3