Control Package; The Check Point Display; The Temperature Displays; The Control Pads - Whirlpool ED26SS Use & Care Manual

Performance Control Package
There are three parts to the SYSTEMS SENTINEL@ II Performance
Control Package.
The Check Point Display
The Refrigerator and Freezer Temperature Displays
The Control Pads
The SYSTEMS SENTINEL@ II Performance Control package will
help you operate the refrigerator effectively and economically,
Read the following information carefully. Then keep this book in a
handy place for later reference.
Instruction labels for using the SYSTEMS SENTINEL@' II Per-
formance Control Package are located inside the Utility
Compartment.
The Check Point Display
Thus display has symbols that glow or flash and
makes a soft beeping sound for the following,
covered in the following pages.
l
Indicates when special features are being used.
The Refrigerator and Freezer Temperature Displays...
The Temperature Displays indicate the tem-
ing temperature is warmer than the acceptable tem-
peratures in the two compartments. These displays
perature range. (Note: The position of the arrow
represent the approximate operating temperature
may change during normal operation.)
The Control Pads...
Each Pad controls a special operating or monitor function for the refrigerator Every time a pad is
touched you will hear a beep
TEMP DISPLAY ON/OFF
Touching the TEMP DISPLAY ON/OFF
Pad turns the Temperature Displays on
and off. This does not affect the actual
monitoring of the refrigerator and freezer cornpar
ment temperatures. It just turns out the lights behind
the displays so they are not constantly visible. If the
refrigerator temperatures become TOO WARM, the
TEMP DISPLAY ON/OFF Pad will not work until tem-
peratures are back within the normal operating
range.
When the MAX FREEZE/ICE Pad is
touched, the MAX FREEZE/ICE Signal
Light comes on and maximum cooling
is provided to the freezer compartment for 24 hours.
This feature is designed to provide faster freezing and
maintain freezer temperatures after adding foods to
be frozen. The MAX FREEZE/ICE Signal Light stays on
until the 24 hour cycle is complete or is cancelled by
touching the RESET/TEST Pad.
MAX COOL
. q
RESET/TEST
The RESET/TEST Pad is used to demon-
When the MAX COOL Pad is touched,
strate ortest the SYSTEMS SENTINEL@ II
the MAX COOL Signal Light comes on
and maximum coolina is provided to
Performance Control Package dis-
plays. It will erase most Check Point Display Symbols
after the problems have been corrected, and cancel
MAX COOL and MAX FREEZE/ICE operations. When
the refrigerator is first plugged in, a touch of the RESET/
TEST Pad will stop the beeping alarm until the re-
frigerator has reached the proper operating tem-
peratures. (See page 4.)
. Elii
MAX FREEZE/ICE
the refrigerator compartment for 24 hours. This is es-
pecially good for maintaining the operating tem-
perature after adding large amounts of foods. The
MAX COOL Signal Light will stay on until the 24 hour
cycle is complete or is cancelled by touching the
RESET/TEST Pad.
6