Table of Contents
Advertisement
VRZ220/250 layout
4/8/99 10:11 PM
32 Rerecording (Tape Duplication)
The instructions on this page show you how to copy tapes. The illustration uses two VRZ250 VCRs.
Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow
steps 1 - 7.
VCR 1
Playing VCR
AUDIO
L
OUT
IN
R
VIDEO
CH3
CH4
IN
OUT
Audio and Video cables are not supplied.
1
Make the connections shown above.
2
VCR 1 will play your tape. Put a prerecorded tape in VCR 1.
3
VCR 2 will record your tape. Insert a blank tape in VCR 2. The
VCR must be in VCR position. (The VCR/TV light will appear on the
display panel. If it does not, press the VCR/TV button once.)
4
Turn on the TV and set it to channel 03 or 04, whichever
channel the CH3/CH4 switch on VCR 2 is set to.
5
Point the remote control at VCR 2. Press Number buttons
0, 0 to select Line Input. A/V IN will appear on-screen.
6
Use the SPEED button to select SP, LP, or SLP at VCR 2.
7
Press the PLAY button on VCR 1 and the REC(ord)/OTR
button on VCR 2 at the same time.
To stop recording, press the STOP/EJECT button on VCR 1, then
press the STOP/EJECT button on VCR 2.
Page 32
1. Audio cables from AUDIO OUT Jacks
of VCR 1 to AUDIO IN Jacks of VCR 2
ANT
IN
OUT
2. Video cable from VIDEO OUT Jack
of VCR 1 to VIDEO IN Jack of VCR 2
VCR 2 - Recording VCR
AUDIO
OUT
VIDEO
OUT
• Unauthorized recording of copy-
righted television programs, video
tapes, or other materials may
infringe on the rights of copyright
owners and violate copyright laws.
• The VCR in the figure above is the
VRZ250. If you have the VRZ220,
use a single-plug audio cable to con-
nect the AUDIO OUT Jack on VCR 1
to the AUDIO IN Jack on VCR 2.
ANT
IN
L
IN
R
OUT
CH3
CH4
IN
3. RF coaxial
cable from VCR's
OUT Jack to TV's
ANTENNA IN
Jack
Helpful Hints
Advertisement
Table of Contents
