Installation Instructions - Wells H-33 Operation Installation Maintenance Manual

INSTALLATION INSTRUCTIONS:

1. Remove Hotplate carefully from carton. Remove all loose packaging and accessories.
2. IMPORTANT: Read all installation instructions carefully BEFORE starting installation.
3. It is the responsibility of the installer to comply with local codes.
4. Any installation not matching the specifications discussed in this manual will void the warmers
warranty.
Installing Countertop Hotplates:
1. Carefully place hotplate on a suitable countertop or table.
2. Hotplates are equipped with 4-inch adjustable legs (1-inch legs for Model H-115). Screw legs (4 each
packed with unit) into holes on bottom corners of hotplate. Set unit upright on countertop or table.
CAUTION:
3. H-63 Hotplates are provided with power cord. All Hotplates are equipped with a spacer to keep unit
spaced properly from the wall. SPACER SHOULD NOT BE REMOVED FOR ANY REASON!
WARNING:
4. Plug unit into a grounded 120V or 208/240V (depending on the model purchased), single phase
receptacle. Check metal rating plate on the unit to verify correct voltage. Hotplate models without
cordsets should be hardwired by a licensed electrician to the correct voltage. MAKE SURE THAT
INCOMING VOLTAGE IS THE SAME AS UNIT IS RATED FOR..
Electrical Grounding Instructions: Hotplates with power cords are equipped a three-prong (grounding)
plug for your protection against shock hazard and should be plugged directly into a properly grounded three-
prong receptacle. DO NOT CUT or remove the grounding prong from this plug.
Installation Requirements/or Built-in Hotplates:
1. Built-in hotplates must be installed into an all metal countertop.
2. The specification sheet covers Underwriters Laboratories conditions of acceptability, installation,
fabrication, and cut-out dimensions.
3. The installation of Built-in Hotplates varies depending on the model chosen. Each hotplate has
features and capabilities that affect the installation.
4. There must be a minimum 1-inch clearance between the unit and rear wall of the counter;
minimum '/4-inch clearance between the unit and adjacent cooking appliances; minimum 2-inch
clearance between the unit and side wall of counter; minimum 9-inch clearance between the
countertop and bottom metal shield.
5. The metal shield must be a minimum No. 22 MSG, and installed at least 9-inches below the
countertop (may have openings which will not permit entrance of a %-inch diameter rod). Please
review specification sheet carefully before beginning installation of Built-in Hotplates. Final
installation must meet all local codes.
HOTPLATES SHOULD NOT BE OPERATED WITHOUT HAVING
LEGS INSTALLED.
HOTPLATES SHOULD MAINTAIN A MINIMUM CLEARANCE OF
1-INCH FROM COMBUSTIBLE WALLS FROM THE SIDES AND
REAR OF THE UNIT.
6