Unit Installation - Safety Track UCIT Installation And Configuration Manual

Safety Track 249 Main Street Belleville, MI 48111 888‐286‐9829
Unit Installation
Mounting DVR
Mount the DVR unit inside the vehicle, with the below considerations:
Unit should be mounted in an area that has no exposure to potential moisture
•
• When mounting unit, choose a location that will deter operator tampering but facilitate access
to the CF cards should they need to be removed for manual review.
• All wiring harnesses should be protected with conduit, and rubber grommets should be used for
all through‐metal runs to prevent chafing of the wires.
• Unit is to be mounted using a screw‐type fastener. No adhesive or Velcro should be used.
Mounting Cameras
Mount the cameras in the areas that are to be monitored, with the below considerations:
The Cameras are not to be installed in any location that will interfere with the
•
driver/operator's direct line of sight.
• Outdoor cameras should use rubber grommets for all through‐metal runs and sealed with a
silicone to prevent wind noise or moisture from entering the vehicle.
• Always dry‐run your cables and connect the cameras to ensure they are recording what is
intended and at the right direction (e.g. not upside down).
• Interior camera cables should be tucked into interior panels/under carpet to prevent tampering,
damage, and potential interference with the driver/operator.
Mounting Optional Speaker and Microphone
If the optional microphone is being installed, install inside the vehicle with the below considerations:
• The microphone should be installed close to the driver/operator to ensure clear audio is heard.
The best place for microphone placement is typically the 'A' pillar of the vehicle.
• Speaker(s) should be mounted close to the driver/operator to ensure they can hear clearly
without having to distract themselves to focus on the speaker location.
8