Advertisement
Quick Links
Advertisement
Related Manuals for Safety Track UCIT LIVE HD
Summary of Contents for Safety Track UCIT LIVE HD
-
Page 1: Installation Manual
UCIT LIVE HD 4 Camera DVR Installation Manual 04/17 Version 1.0... -
Page 2: Tools Required
This is a step by step guide that will walk you through installing the UCIT LIVE HD 4 Channel Camera System. Basic wiring experience and knowledge is required at the minimum. Please follow each step, otherwise your system may not work properly. If you have any questions regarding the installation of this system contact Support at 888-286-9829 Press #6 or Support@SafetyTrack.net. -
Page 3: Getting Started
Review packing list or “whats in the box” to make sure you have everything. NOTE: Any modifications to the device or software outside of company standards without company approval are not a responsibility of Safety Track and will void the warranty. Getting Started: Familiarize yourself with the contents of the box. - Page 4 Step 1: Find a suitable location to mount the DVR in such a way that is accessible to the fleet manager. (To pull SD card and for troubleshooting) The DVR can also be hidden if requested. Step 2: After unboxing the equipment, and getting acquainted with what’s included, start by plugging in accessories.
- Page 5 C. Plug in the Accessory Harness for the microphone (If Applicable). Follow the steps below to ensure proper connection of the microphone: B1. - Find the Accessory Find the Microphone Harness RCA (Female) Extension White Wire Only Yellow RCA (Male) and Red plug (Female) Plug the Yellow RCA (Male) from Microphone...
- Page 6 Plug Yellow RCA (Male) Plug Red Plug (Male) from Microphone from Microphone Extension into White Extension into Red RCA (Female) on Plug (Female) on Microphone Microphone Place the Microphone so that it is visible and in an optimum position to get the best clarity. Pictured right is a recommended placement example.
- Page 7 Camera Model: ST-1231 Ensure cameras are properly aimed by adjusting the 4 screws on both sides of the camera shown at the right. This camera example, as you can see, has also been mounted with 3M trim tape. The bracket attached to this camera is steel and will allow for screw mounting a a bit easier.
- Page 8 When it comes to the interior (Non-IVR) Camera there is a small grove etched into the back. (Shown Right) This indicates when the camera is up right and in the proper position. Etching should line up with the T in the bracket. You may need to loosen the allen/hex screw with the supplied key.
- Page 9 This step describes how to plug in the cameras and mounting. Which ever you prefer to do first. In most cases it is easier to mount the cameras as long as you know you will have enough cable. NOTE: Be sure to line up the arrows on both ends of this connection otherwise the cameras won’t connect and you could damage the pins.
- Page 10 Step 7: Ensure proper connection by checking the lights on the DVR. If you see lights then you have power. It may take a few seconds for lights to come on after you connect. Red = Recording. Blue = GPS. Orange = Network. -Red will consistently blink every second or so to indicate recording and writing to the memory card.