3.
Check and Preparation
3.1
Checking the Package Contents
This product package includes the following items:
□Main Unit ZN-CTX21
□AC Adapter or DC cable
□Alarm Output Connector
□Instruction Sheet
□Startup Guide
□Mounting Magnet (Pre-installed)
3.2
Preparing the Required Items
The following items are required to use this product.
(1)
Common
□Dedicated CT: ZN-CT1-A
Up to three units can be connected when using a branch cable (ZN-CTM11-C)
□PC (personal computer) for the PC software 1
Refer to: 3.4.2 Operating Environment
□SD Memory Card (SDHC compatible)
Used to save measured data or to relocate the data (when recording in a Portable Power
Monitor unit)
□AAA batteries (when using battery power supply)
Alkaline dry cells or nickel-metal hydride cells (Ni-MH)
Important
Manganese battery cells cannot be used.
Use two batteries of the same type. Do not mix new and used batteries.
(2)
Network Connection
□LAN Cable (10BASE-T or 100BASE-TX; Safety Category 5e or higher; Straight Type)
□LAN Connection HUB (for 10BASE-T or 100BASE-TX)
Note
Generally, Portable Power Monitors should be connected to a PC via a HUB.
1
1
1
1
1
2
1 (Separately sold)
1 (Recommended: HMC-SD291, 2 GB)
2
3-1
3. Check and Preparation