Stick Welding - Vulcan-Hart OMNIPRO 220 Owner's Manual & Safety Instructions

Stick Welding

TO pREVENT SERIOUS INJURy ANd dEATH:
do not weld without grounding clamp.
When the operator is not holding the Electrode Holder, it must be
sitting on a nonconductive, nonflammable surface.
1. Turn the Power Switch to the OFF position, then
plug the Welder into a properly grounded, GFCI
protected, 120 V AC (20 amp rated) outlet or
240 V outlet. The circuit must be equipped with
delayed action-type circuit breaker or fuses.
2. Set Electrode Holder down on
nonconductive, nonflammable surface
away from any grounded objects.
3. Turn the Power Switch ON.
4. Press Home Button on Control Panel.
5. Turn Main Control Knob until Stick process
appears on LCD display screen.
6. Press Main Control Knob to select STICK process.
Note: Press Main Control Knob to go to next screen.
Press Back Button to return to the previous screen.
Left
knob control
knob
7. Adjust settings for the STICK process.
a. Polarity Setting:
• Plug cables in according to screen.
Page 32
Stick
Main Right
knob
For technical questions, please call 1-888-380-0318.
b. Set Electrode type:
• Turn Main Control Knob to set electrode type.
c. Set Electrode Diameter and Material Thickness:
• Turn Left Knob to set electrode diameter.
• Turn Right Knob to set material thickness.
d. Auto Weld Settings:
• Turn Left Knob to adjust output amperage.
• Turn Right Knob to ON to
energize Electrode Holder.
WARNINg! Welder is now energized and
Open circuit Voltage is present.
process
Electrode
Type
Hot Start
Electrode
diameter
Material
Thickness
Arc Force
Item 63621