Mig / F Lux-Cored Wire Welding - Vulcan-Hart OMNIPRO 220 Owner's Manual & Safety Instructions

MIG / F lux-Cored Wire Welding
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
Note: Remove the protective foam and cardboard from the Welder before setup.
Wire Spool Installation / W ire Setup
1. Turn the power Switch OFF and unplug
the Welder before proceeding.
2. Pull up on the Door Latch,
then open the Door.
3. 1-2 pound Wire Spool Installation:
Remove the Wingnut and Spacer. If
replacing a Spool, remove the old Spool
and all remaining wire from the liners.
4. Place the new Wire Spool over the Spool Spindle
and against the Spool Brake Pad as illustrated.
To prevent wire feed problems, set the
Spool so that it will unwind clockwise.
5. Replace the Spacer over the
Spool Spindle and secure Spool
in place with the Wingnut.
Notice: If Wire Spool can spin freely, Wingnut is too
loose. This will cause the welding wire to unravel and
unspool which can cause tangling and feeding problems.
Page 10
TO pREVENT SERIOUS INJURy FROM AccIdENTAL OpERATION:
Turn the power Switch off and unplug the Welder before setup.
For technical questions, please call 1-888-380-0318.
door
door
Latch
Wingnut
Spacer
Spool
Spindle
1-2 lb Spool Loading
power
Switch
1-2 lb
Wire Spool
Spool
Brake pad
Welder
Wall
Item 63621