Table of Contents
Advertisement
6. 10-12 pound Wire Spool Installation:
Remove the Wingnut and Spacer. If
replacing a Spool, remove the old Spool
and all remaining wire from the liners.
7. Place the Spool Adapter over the Spool Spindle
and against the Spool Brake Pad as illustrated.
8. Place the new Wire Spool over the Adapter and
line up pin on Adapter with hole in Spool.
To prevent wire feed problems, set the
Spool so that it will unwind clockwise.
9. Replace the Spacer over the Spool Spindle
and secure Spool in place with the Wingnut.
Notice: If Wire Spool can spin freely, Wingnut
is too loose. This will cause the welding
wire to unravel and unspool which can
cause tangling and feeding problems.
10. Screw the Spool Knob into the Spool Adapter.
11. Turn the Feed Tensioner knob counterclockwise to
loosen it enough to pull it down to remove tension.
The spring-loaded Idler Arm will move up as shown.
Item 63621
For technical questions, please call 1-888-380-0318.
10-12 lb
Spool
Adapter
10-12 lb Spool Loading
Wire
must
unwind
in this
direction
Feed Tensioner
Spool knob
Wingnut
Spacer
10-12 lb
Wire Spool
Spool Spindle
Spool
Brake pad
Welder
Wall
Idler Arm
Page 11
Hide quick links:
Advertisement
Table of Contents
