Ricoh PRO C900S Network Manual page 60

1. Monitoring and Configuring the Machine
add_sess_IPX: bad trap addr: <IPX address>,
community: <community name>
1
add_sess_IPX: community <community name>
already defined.
Connected DHCPv6 server <IPv6 address>
connection from <IP address>
Current Interface Speed: xxxMbps
DHCPv6 server not found.
Duplicate IP = <IP address> (from <MAC
address>).
(IKE phase-1) mismatched authentication type:
local=<authentication type 1>
remote=<authentication type 2>
(IKE phase-1) mismatched DH group: local=<DH
group number 1> remote=<DH group number 2>
(IKE phase-1) mismatched encryption type:
<encryption algorithm 1> remote=<encryption
algorithm 2>
58
Message Problem and solutions
The IPX address (00:00:00:00:00:00) is
unavailable when the community access type is
TRAP. Specify the host IPX address for the TRAP
destination.
The same community name already exists. Use
another community name.
The IP address was successfully received from the
DHCPv6 server.
A user logged in from the host <IP address>.
Speed of the network (10 Mbps, or 100 Mbps).
The DHCPv6 server was not found. Make sure that
the DHCPv6 is on the network.
The same IP address (IPv4, or IPv6 address) was
used. Each IP address (IPv4, or IPv6 address) must
be unique. Check the address of the device
indicated in [MAC address].
This machine's <authentication type 1> in IKE phase
1 does not match the communicating host's
<authentication type 2>, Make sure this machine's
ISAKMP SA authentication type matches that of the
communicating host.
This machine's ISAKMP SA Oakley group <DH
group number 1> in IKE phase 1 does not match
the communicating host's ISAKMP SA Oakley
group <DH group number 2>, Make sure this
machine's ISAKMP SA Oakley group matches that
of the communicating host.
This machine's ISAKMP SA Oakley group
<encryption algorithm 1> in IKE phase 1 does not
match the communicating host's ISAKMP SA
Oakley group < encryption algorithm 2>, Make
sure this machine's ISAKMP SA Oakley group
matches that of the communicating host.