Intermediate Assembly - Sandpipper S05 Operating And Service Manual

Intermediate assembly

26
Intermediate Assembly drawing
Step 1: Remove plunger, actuator (25) from center of
intermediate pilot valve cavity.
Step 2: Remove Ring, Retaining (26), discard.
Step 3: Remove bushing, plunger (7), inspect for wear
and replace if necessary with genuine parts.
Step 4: Remove O-Ring (21), inspect for wear and
replace if necessary with genuine parts.
Step 5: Lightly lubricate O-Ring (21) and insert into
intermediate.
Step 6: Utilizing a new Ring, Retaining (26) reassemble
in reverse order
Step 7: Remove Seal, Diaphragm Rod (35).
Step 8: Clean seal area, lightly lubricate and install new Seal,
Diaphragm Rod (28).
IMPORTANT
When the pumped product source is at a higher
level than the pump (flooded suction condition),
pipe the exhaust higher than the product source
to prevent siphoning spills. In the event of a
diaphragm failure a complete rebuild of the
center section is recommended.
www
s05mdl1sm-rev1113
21
7
25
. .
sandpiperpump com
4
21
25
Intermediate Repair Parts list
Item Part Number description
4 114.023.157 Bracket, Intermediate
114.023.551 Bracket, Intermediate
114.023.559 Bracket, Intermediate
(Conductive Polypropylene
Midsection ONLY)
7 135.036.506 Bushing, Plunger
28 560.001.360 O-Ring
32 620.019.115 Plunger, Actuator
33 675.042.115 Ring, Retaining*
35 720.012.360 Seal, Diaphragm Rod
*Note: It is recommended that when plunger components are serviced,
new retaining rings be installed.
ATEX Compliant
7
26
Qty
1
1
1
2
2
2
2
2
16
Model S05 Metallic •