Installing Batteries - Uovision UM785-3G Instruction Manual

Operation Panel
MENU: To enter the menu, the power switch should be on SETUP.
▲▼◄►: Navigation arrows. ("▲"is the shortcut to choose "Video", while "▼"for the "Photo".)
OK : Save parameter settings. Exchange between playback and preview.
►Shot: To capture a photo or record a video manually. (Click ►again to stop the video.).
Power Switch: OFF: turn off the power; SETUP: change camera settings; ON: enter working mode.

3 Installing batteries

To supply power for the camera, 4, 8 or 12 size AA batteries are needed.
Confirm that the power switch is on the OFF position; load the fully charged batteries into the pack according to
the polarities signs shown below. The following batteries with 1.5V output can be used:
1. High-density and high-performance alkaline batteries (Recommended)
2. Rechargeable 6V external battery
There are 6 battery slots. Slot 1 and 2 form one group and is marked "1", slot 3 and 4 form the other group and
is marked "2", while slot 5 and 6 form the other group and is marked "3". Single "group" of batteries is needed to
supply power to the camera, but both can be used and is recommended.
Figure 3 Bottom View
Figure 4 Battery Config
Page 2