Page 1
QUICK GUIDE C A R D O S Y S T E M S , I N C . Cardo S-800 ™ Bluetooth Headset ®...
Page 2
Congratulations and thank you for choosing the Cardo S-800 Bluetooth headset. This Quick Guide will help you learn about ® the Cardo S-800’s many features, allowing you to make the best use of your headset. Cardo S-800 Overview 1 Microphone...
Cardo S-800 ™ Getting Started To use your Cardo S-800 (“the headset”), please follow these initial steps: • Charge your headset • Pair your headset with a Bluetooth -enabled mobile phone. ® 1. Charging your Headset The headset comes with a built-in rechargeable battery. Prior to using the headset, make sure to charge the headset for at least 4 hours.
This is usually found in the phone’s Bluetooth menu and may referred to as “discover” or “add” a device. 4. After a few seconds, the phone will list the “Cardo S-800” as a discovered device. Select it from the list and press “OK” or “Yes”.
Page 5
Cardo S-800 ™ 5. When prompted, enter the passkey “0000” (4 zeros) and press “OK” to complete the pairing. 6. When the pairing is complete, your phone will confirm that the pairing was successful and the headset’s LED status indicator will begin flashing slowly in blue.
™ 3. Wearing your Headset The S-800 headset can be worn on either your left or right ear. There are two ways in which you can wear the S-800 headset. 1. Without the earloop: Gently insert the headset without an earloop into your ear, and it will hold itself in place securely.
Page 7
Cardo S-800 ™ 4. Using your Headset – Basic Functions Function Required Action Turn ON/OFF the Press and hold the Power Button for at headset least 4 seconds Answer a call Tap the CTRL Button* End a call Tap the CTRL Button...
Page 8
Cardo S-800 ™ 5. Using your Headset – Advanced Functions 1. Redial the last dialed number* During Standby, press the MFW inwards to redial the last dialed number. . Reject an incoming call* During an incoming call, press and hold the CTRL Button for 3 seconds.
Page 9
Tap the Hot Dial Button three times rapidly. 7. SWAP (Swapping connection between two active mobile phones) The S-800 allows you to swap, i.e. to alternately use one among the last two phones to which it has been connected. To SWAP between phones: •...
Page 10
Medium charge Weak charge • Red . Locating the Headset (Buzzer Function) The S-800 allows you to locate the headset by activating an audible buzzer. To activate the Buzzer: • Dial a number with the mobile phone and press Send/Talk.
Page 11
• The headset will start buzzing. 10. Call back the last incoming caller (Callback Function) The S-800 allows you to place a call to the phone number of the last incoming call. The headset will store the phone number of the last answered, missed or rejected call.
Page 12
Cardo S-800 ™ using the Auto-Answer function. Please note that once this feature is activated you are subject to unintended eavesdropping. Use of this feature is at your own risk! Learn more at www.cardosystems.com/faq/autoanswer When Auto-Answer mode is enabled on an incoming call, the Headset will ring for a few seconds and then automatically answer the call without the need to press the CTRL Button.
Page 13
Cardo S-800 ™ 1. Button Lock The S-800 allows you to lock its buttons, preventing the buttons from being accidentally pressed. To lock/unlock the buttons on the Headset: • While in Standby mode, simultaneously press the MFW and the CTRL Button for at least four seconds.
Page 14
Cardo S-800 ™ If you wear the Headset on your left ear, the S-800 allows you to change the MFW orientation from right to left ear, so that pressing the MFW up still increases the volume, and pressing down decreases the volume. Only volume orientation is affected.
Page 15
Cardo S-800 ™ ADVANCED FUNCTIONS REFERENCE Function Required Action Redial the last dialed During Standby, tap the MFW inwards. number Reject an incoming During an incoming call, press and hold call the CTRL Button for 3 seconds. Call waiting / Toggling...
Cardo S-800 ™ Function Required Action Auto-Answer On/Off During Standby mode, press and hold the MFW upwards for 7 seconds. Button Lock On/Off During Standby mode, simultaneously press the MFW and the CTRL Button for at least 4 seconds. Disabling / enabling the...
Page 17
Cardo S-800 ™ The headset uses the following Status Indicators to display its status: Auto- Status Light Status Answer Single blue flashing Standby mode Disabled slowly (every 3 sec) Double blue flashing During a call Disabled slowly (every 3 sec)
Cardo S-800 ™ Auto- Status Light Status Answer 3 red flashes Power OFF Headset is off or None Status Indicator is disabled 7. Audio Tones With the exception of the actions described in the following table, all actions are followed by a single tone to confirm that the headset has accepted the action.
Problem Action Pairing fails 1. Delete S-800 from your paired device list in your phone (if it is listed). 2. Turn off the mobile phone and Headset. 3. Take the battery out of the phone and put it back.
Page 20
Cardo S-800 ™ Problem Action Battery does Make sure your headset is fully charged. Charging time is up to 2 hours for an empty battery. not provide When fully charged and charger is connected to at least six headset, the red light indicator turns off.
Page 21
Cardo S-800 ™ Problem Action I am unable to 1. Ensure your headset is turned on and is properly charged. connect the 2. Ensure the headset is paired with your mobile headset with the phone. mobile phone 3. Ensure your mobile phone’s Bluetooth feature is or Bluetooth activated.
Page 22
+1 412 788 4533 Email: support@cardosystems.com FAQ: www.cardosystems.com/faq ® The Cardo S-800™ Headset is compliant with and adopts the Bluetooth Specification 2.0. However, interoperability between the device and other ® Bluetooth -enabled products is not guaranteed. For more information on the compatibility between the device, please visit our website at: www.cardosystems.com/declaration...
Page 24
Cardo S-800 ™ IMPORTANT SAFETY INSTRUCTIONS 1. Make sure the voltage specs of your Wall Charger fit your power grid (110 V or 220 V). 2. Don’t touch the Wall Charger while your hands are wet. 3. Never try to open the wall charger.
Page 25
What this limited warranty covers and for how long: Cardo Systems, Inc. (the “Company” or “Cardo“) warrants the Product and Wall Charger against defects in material and workmanship under normal use and service for a period of...
Page 26
The battery is used in equipment other than the equipment for which it was intended. The Company disclaims all responsibility for any equipment not furnished by Cardo Systems Inc., which is attached to or used in connection with the Product.
Page 27
Cardo S-800 ™ 1. Cardo is not liable for any incidental or consequential damages arising from the use or misuse of any of the Company’s Products. 2. The user should never attempt to perform service, adjustments or repairs of the Product by him/herself. Doing so will void all warranties.
Page 28
European CE Notice - Certification and Safety Approvals/ General Information This Product is CE marked according to the provisions of the R & TTE Directive (99/5/EC). Hereby Cardo Systems, Inc. declares that this Product is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.