Connect To The Internet - Link4 iPonic 624 User Manual

The iPonic™ 624 comes with a preinstalled Communication Module.
The controller can be used to access the Internet with a standard CAT 5
cable that can be linked to your router.
Note: The Ethernet port for the Internet is inside the iPonic™ 624.
Before proceeding, make sure the Ethernet cable is functioning properly.
Perform the following steps to connect your iPonic™ 624 to the Internet:
- Power down the controller
- Open up the hinged door
- Route cable through opening at the base
- Locate the Ethernet port in the upper left corner
- Plug in the cable to the Ethernet port
- Plug in the other end to your router
- Close and lock the controller door
- Power up the controller
Once you're connected to the Internet, the controller will automatically
link up to the Link4 Cloud Server (iponic.link4cloud.com) and a
Registration Key will be created for you. Use the instructions below to
access the Registration Key:
- From the Main Menu, Press Soft Button No. 3 or use the
Navigation Menu to highlight System Setup
- Press Soft Button No. 7 or use Navigation Menu to highlight
Communication Setup
- Press Soft Button No. 2 or use Navigation Menu to highlight
Server Setup
- View your Serial Number and Registration Key
Once you have a Registration Key assigned, go to the browser on your
computer or mobile phone and visit the Link4 Cloud
(iponic.link4cloud.com). If you haven't done so already, please create an
account.
Once you have connected to your iPonic 624 through the internet and
then setup your remote access you will begin receiving text message
alerts. (See pg. 14) These will show up as iPonic Alert Notification.
You will have the capacity through the Link4 Cloud to receive 25 of
these notifications every 12 hours. Make sure that you are checking your
controller if you get 25 and it has not been 12 hours, because you will
not get your next alert until the time resets.
iPonic™ 624 User Manual

Connect To the Internet

Text Message Alerts
Page 13 of 56