Adjusting The Drip Tray; Setting Up Your Dualbrew Single Serve Coffee Maker Using The Capsule Adaptor - Bella 14585 Instruction Manual

Adjusting the Drip Tray

1. Grasp the drip tray and cover from the base. (See Figure 2.)
2. Holding on to both pieces, slightly tilt upwards and slide out from the unit. (See Figure 3.)
3. Using the tab on the back of the drip tray as your guide, again slightly tilt both pieces upwards and
glide the tabs into the upper slots on the Coffee Maker body. (See Figure 4.) Press down on the drip tray
with your hand to make sure it is firmly and properly attached before placing the cup or mug on top.
Figure 2

Setting Up your Dualbrew Single Serve Coffee Maker Using the Capsule Adaptor

WARNING: Before brewing, it is recommended the water tank be filled at least to the MIN indicator line.
To avoid damage to your Coffee Maker, never operate your Single Serve Coffee Maker when the water tank is empty.
1. Grasp the removal water tank using the designated grips. Lift the water tank up and remove it from
the base of the unit. (See Figure 1.)
2. Remove the lid and fill the water tank to the MAX indicator line with cold water.
NOTE: Never fill the water tank past the MAX indicator line and ensure water level is above the MIN
indicator line.
IMPORTANT: For optimal flavor, distilled water is preferred.
3. Put the lid back and put the water tank back into place. Place down firmly to make sure it is securely in place.
4. Select the desired height for the drip tray, depending on the size of the cup, mug, or tumbler being used
5. Place the empty cup, mug, or tumbler in position on the drip tray cover
6. Pull the adaptor compartment's front tab up to unlock and lift the lid.
7. Choose the capsule adaptor. Add the capsule of your choice into the adaptor. Press down on the capsule
until it is flush with the adaptor.You will hear a pierce as the needle penetrates the capsule.
8. With the handle facing front, place the capsule adaptor into the adaptor compartment.
Slide the adaptor handle in to the grooves at the front of the Coffee Maker.
9. Press the adaptor compartment's lid down firmly. An audible click can be heard as the lid is locked
firmly into position, and the top of the capsule will be punctured.
10. Plug the Coffee Maker into a 120V AC electrical wall outlet
11. To select the brew size (6 oz., 10 oz., or 15 oz.), press the Size button until the indicator light illuminates
the desired size.
12. Press the Capsules button to begin the brew cycle.
13. The red PREHEAT indicator light will begin to flash as the Coffee Maker begins heating the water.
14. When the water has reached the optimum temperature, the preheat light will go out
and the blue BREW light will illuminate.
15. The pump will then activate and coffee will begin to stream through the nozzle.
16 To interrupt the brewing cycle at any time, press the Capsules button.
Then remove the plug from the wall outlet.
17. At the end of the cycle, the Coffee Maker and all indicator lights will automatically turn OFF.
18. Allow unit to cool before removing the used capsule to discard.
19. Unplug the Coffee Maker when not in use.
Figure 3
Upper
Slots
6
Figure 4