Reset To Factory Default - Silex technology SD-300 User Manual

If SD-300/SD-320AN has been used in a particular network and you wish to change the
settings to use it for another network, please initialize SD-300/SD-320AN first according to
the instructions below:
<<Reset using the RESET switch on SD-300/SD-320AN>>
* It is recommended to take notes of the current settings. You cannot restore it once the factory default
configuration is complete.
TIP
* Before you start, please make sure that no PCs are currently linked.
* Do not turn off SD-300/SD-320AN while resetting to factory default.
* Do not press the push switch on the top when turning on SD-300/SD-320AN again after it was reset to the
factory default settings.
* The following settings will remain even after finishing the factory default configuration.
* Network Conf. - General - System Description
* Network Conf. - Wired LAN - LAN Interface
1.
Press and hold the push switch with a fine tipped object such as a pen or pencil when
the SD-300/SD-320AN is powered on. Keep pressing it for 5 or more seconds.
Push Switch
2.
The factory default configuration will begin when the push switch is released.
3.
When the factory default configuration has completed, the SD-300/SD-320AN will
automatically be restarted after the orange LED turns off.

Reset to Factory Default

SD-300/SD-320AN
7. Other Functions
131