Table of Contents
Advertisement
5. GENERAL MAINTENANCE
Replacing the power cable
If the power cable for this equipment is damaged, it must be replaced
by the manufacturer or its after-sales service or similarly trained
personnel to avoid danger.
Cleaning
• K eep all safety devices and the motor housing free of dirt and dust
as far as possible. Wipe the equipment with a clean cloth or blow
it with compressed air at low pressure.
• W e recommend that you clean the device immediately each time
you have finished using it.
• C lean the equipment regularly with a moist cloth and some soft
soap. Do not use cleaning agents or solvents; these could attack
the plastic parts of the equipment. Ensure that no water can seep
into the device. The ingress of water into an electric tool increases
the risk of an electric shock.
Storage
Store the equipment and accessories out of children's reach in a
dark and dry place at above freezing temperature. The ideal storage
temperature is between 5 and 30 °C. Store the electric tool in its
original packaging.
NOTE:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the Bench Grinder & Belt Sander by
an unauthorised person or by mishandling of the Bench Grinder &
Belt Sander.
DESCRIPTION OF SYMBOLS
V
Volts
~
Alternating current
Revolutions or
min -
¹
reciprocation per minute
m/s
Meters per second
Regulator compliance
mark
Read instruction manual
Wear ear protection
CARING FOR THE ENVIRONMENT
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
SPARE PARTS
Grinding Wheel Fine
Grinding Wheel Coarse
Sanding Belt Set (5Pcs)
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: enquires@ozito.com.au
Hz
Hertz
W
Watts
n
No load speed
o
Diameter
Ø
Wear gloves
Wear eye protection
Warning
4412512
4412513
4419809
Advertisement
Table of Contents
