TP-Link TD854W User Manual page 27

Error! AutoText entry not defined.
 Encapsulation: Specifies the type of Multiplexing, either LLC or VC-Mux. Please note
that VC-Mux is not available for IPoA channel mode.
 Channel Mode: There are six channel modes, 1483 Bridged, 1483 MER, PPPoE,
PPPoA, 1483 Routed and IPoA. Please choose the mode that you want to use.
Enable NAPT: Choose to enable the NAPT function or not.

Enable IGMP: Choose to enable the IGMP function or not.


PPP Settings: These parameters are only available for PPPoE and PPPoA channel mode.
User Name: Enter your user name for your PPPoE/PPPoA connection.

 Password: Enter your password for your PPPoE/PPPoA connection.
Type: Select Continuous, Connect on Demand or Manually for the network

connection. Continuous means the Internet connection will always keep on. Connect
on demand is dependent on the traffic. If it's idle (there is no traffic) for a pre-specified
period of time), the connection will tear down automatically. And once there is traffic send
or receive, the connection will be automatically on. Manually means you have to
manually connect or disconnect your Internet by clicking the Connect or Disconnect
button at the bottom of this page.
Idle Time (min): Specifies the idle time for Connect on Demand type.


WAN IP Settings: These parameters are only available for 1483 MER and 1483 Routed
channel mode. Please note that for1483 Routed mode, DHCP is not available.
 Type: Selects to use Fixed IP or DHCP. If Fixed IP is selected, then you have to fill the
following parameters, including Local IP Address, Remote IP Address, and Netmask.
Otherwise, these parameters will not be available.
Local IP Address: The IP address of the router on the PVC channel.

Remote IP Address: The gateway's IP address of the router on the PVC channel.

Netmask: The subnet mask of the router on the PVC channel.

 Connect/Disconnect: When there is a VC using PPPoE/PPPoA channel and Manually type,
you need to click this button to connect/disconnect the network.

Add: Click this button to add a VC. First fill the parameters above and then click this button,
thus your new VC will be added to the Current ATM VC Table.
 Modify: Click this button to modify your existed VC. First choose the desired VC and modify
the parameters, and then click this button, thus your existed VC will be modified.

Delete: Click this button to delete your existed VC. First choose the desired VC, and then
click this button, thus your existed VC will be deleted.
Error! AutoText entry not defined. User Guide
21