JVC CA-FSSD1000R Service Manual page 7

Removing the front panel assembly
Prior to performing the following procedure, remove
the CD door, the rear cover and the side covers.
1. Remove the three screws E on the bottom of the
body.
2. Release two joints a and two joints b on both sides
of the body using a screwdriver and remove the front
panel assembly toward the front.
(Left side)
Removing the CD mechanism base
assembly (See Fig.7 to 14)
Prior to performing the following procedure, remove
the CD door, the rear cover, the side covers and the
front panel assembly.
1. Disconnect the card wire from connector CN104 and
CN105 of the main board in the front part of the
body. Disconnect the card wire from CN101 of the
main board on the right side, and the wire from
CN705 and CN708 of the CD mechanism base
assembly respectively.
2. Remove the four screws F
mechanism base assembly on the upper side of the
body. Remove the screw I
terminal on the right side.
(See Fig.4 to 6)
Front panel assembly
Joints a
Fig.5
attaching the CD
attaching the earth
Bottom
Front panel assembly
Front panel assembly
Joints b
F
CD mechanism base assembly
CN104
FS-SD1000R
E
Fig.4
(Right side)
Fig.6
Fig.7
CD mechanism base assembly
CN105
Main bard
Fig.8
F
1-7