Mechanical Specifications; Regulatory Compliance And Safety Information; Declaration Of Conformity For Rf Exposure; Access Point On Cisco.com - Cisco IW3702 Getting Started Manual

Power INPUT WiFi
4 x 4
MIMO
POE-IN, No(3x3 only)
802.3af (POE,
13W)
7 Refer to Table 14 on page 40 for the restrictions on the temperature limits.
8 When you use a thicker cable, the maximum length can be increased. When the unit is installed in the environment where the temperature is always higher
than -20°C, the maximum length can be double of the value in the table for DC inputs. Furthermore, if the GE-POE-OUT port is not used as POE-PSE (power
source), the maximum length can be increased by 10 feet.

Mechanical Specifications

Table 24: Mechanical Specifications for the Access Point
Description
Enclosure type
Dimensions (h x w x d)
Weight

Regulatory Compliance and Safety Information

For information about the international regulatory compliance and safety information for the Cisco IW3702 access point, see the
Regulatory Compliance and Safety Information for Cisco IW3702 Access Point on Cisco.com.

Declaration of Conformity for RF Exposure

This section contains information on compliance with guidelines related to RF exposure.
Generic Discussion on RF Exposure
The Cisco products are designed to comply with the following national and international standards on human exposure to radio
frequencies:
• US 47 Code of Federal Regulations Part 2 Subpart J
• American National Standards Institute (ANSI) / Institute of Electrical and Electronic Engineers / IEEE C 95.1 (99)
66
GE-POE-OUT GE-POE-OUT
(POE PSE) (10/100/1000)
No No
Specification
IP67 Type 4X
6.7 lbs. (3.0 kg)
Operating Wire Thickness,
Temperature Min Rating
7
Range
-4 to 167°F (-20 CAT5e(24AWG),
to 75°C) 0.6 A, shielded
• IW3702-2E-UXK9: 2.34 x 11.30 x 8.00 in. (5.94 x 28.7
x 20.32 cm)
• IW3702-4E-UXK9: 2.34 x 11.30 x 8.00 in. (5.94 x 28.7
x 20.32 cm)
Length
8
(Max)
100m