Statement - Cisco IW3702 Getting Started Manual

Ultimate disposal of this product should be handled according to all national laws and regulations.
Danger

Statement 1040

To prevent the system from overheating, do not operate it in an area that exceeds the maximum
Danger
recommended ambient temperature of: 70°C Statement 1047
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Danger
Danger This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure
that the protective device is rated not greater than: 15 A. Statement 1005
Do not operate your wireless network device near unshielded blasting caps or in an explosive
Danger
environment unless the device has been modified to be especially qualified for such use. Statement
245B
The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum
Caution
pullout force of 20 lbs (9 kg) and must use all 4 indented holes on the mounting bracket.
The access point is suitable for use in environmental air space in accordance with section 300.22.C of the
Note
National Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part
1, C22.1. You should not install the power supply or power injector in air handling spaces.
Use only with listed ITE equipment.
Note
EMC Environmental Conditions for Products Installed in the European Union
This section applies to products installed in the European Union. The equipment is intended to operate under the following environmental
conditions with respect to EMC:
• A separate defined location under the user's control.
• Earthing and bonding meets the requirements of ETSI EN 300 253 or ITU-T K.27.
• AC-power distribution shall be one of the following types, where applicable: TN-S and TN-C as defined in IEC 60364-3.
In addition, if equipment is operated in a domestic environment, interference could occur.
15