Locating Individual Wire Pairs With The Mt-7068 Analog Function - Pro's Kit MT-7068 User Manual

Locating Individual Wire Pairs with the MT-7068 Analog
Function
To locate cables, do the following (Figure 3):
1. Connect the black alligator clip of the Toner to the ground, and then connect the red clip to a jack or
punch-down block as shown in Figure 3.
2. Turn the Toner's rotary switch to
3. Turn the Probe's rotary switch to
flickers.
4. Use the Probe to find the general location of the tone at a cable rack, patch panel, or behind a wall. In
locating mode, the Probe's LEDs light up in red from 1 to 8, then wrap back and light up from 1 to 8
again as the signal strength increases.
5. Adjust the Volume Control on the Probe to locate the wire pairs from 10cm to 30cm.
Ground
One-note
Tone
Two-note
Tone
for a one-note tone or
. Turn the rotary to
Volume
Control
Figure 3 Locating Cables
for a two-note tone.
position when the LED
Volume Control