Conventional (Furnace) Systems; Heat Pump Systems - Lux Products KONO Installation Manual

Option 1 - Conventional (furnace) Systems:
Step 2.6f: Following the terminal labels
marked "Conventional" on the thermostat
base, press the lever and insert each
labeled wire into the top hole of the
corresponding terminal.
Step 2.7f: If you have both an RC and RH wire present, then remove the
red cap next to the reset button. You can now skip ahead to step 2.8.
Option 2 - Heat Pump Systems:
Step 2.6hp: Following the terminal labels
marked "Heat Pump" on the thermostat base
and referencing your wiring photo, press the
lever and insert each labeled wire into the top
hole of the corresponding terminal.
If your old thermostat did not have a W1 wire but did have a W2 wire,
please insert the W2 wire into the W1 terminal.
Step 2.7hp: If you have both an O wire and a B wire
(i.e. in a Trane system), please install the B wire to the "C" terminal.
For more detailed directions, please see the wiring diagrams in the
appendix or call LUX Technical Support.
INSTALLATION WITH
2. C-WIRE
CONVENTIONAL C
HEAT PUMP C
POWER BRIDGE 1 4
CONVENTIONAL C
HEAT PUMP C
POWER BRIDGE 1 4
LuxProducts.com
W1 W2
W1 OB
2
W1 W2
W1 OB
2
| 9