Lux Products KONO Installation Manual page 14

Step 3.9: i)
ii)
iii)
iv)
i)
Furnace
Y Y G W R G W R C C
1(Y) 1(Y)
Step 3.10: Secure the LUX Power Bridge to your furnace. If you had to
remove a panel or door to access your control panel, replace it now.
Step 3.11: Return power to your heating and cooling system. If your
system, including your thermostat, does not power up please call LUX
Technical Support.
After KONO Smart powers up, you are ready to configure it for your
heating and cooling system and connect to a wireless network.
14 | 856.234.8803
Matching the letters, label the wires connected to your
furnace with the included white Power Bridge wire
labels. Take a picture of the wiring at your control board.
Disconnect these wires from the control board.
Open the Power Bridge and insert each of your old wires
into the corresponding numbered terminals in the Power
Bridge.
Finally, insert the Power Bridge wires (with the colored
labels) into the corresponding terminals on your furnace
control board.
ii)
Furnace
Y Y Y G W R G W R G W R
1(Y) 1(Y) 1(Y) 2(W) 2(W)
4(G) 4(G) 3(R) 3(R)
iii)
C C C Y Y Y G W R G W R G W R
1(Y) 1(Y) 1(Y) 2(W) 2(W) 2(W)
4(G) 4(G) 4(G) 3(R)
iv)
Furnace
C C C Y
C C 1(Y)
3(R) 3(R) 4(G)
G W R C
2(W) C
3(R)