Electrolux EXD16DN3W User Manual page 10

10 www.electrolux.com
Occurrence
Dehumidifier does not operate
Dehumidifier runs too much
Solution
Wall plug disconnected. Push plug firmly
into wall outlet.
House fuse blown or circuit breaker
tripped. Replace fuse with time delay type
or reset circuit breaker.
The dryness level you selected has been
reached. Dehumidifier automatically shuts
off when selected amount of moisture has
been removed from the air. If you want
to remove more moisture, select CON-
TINUOUS by using the humidity button or
knob. After the dehumidifier starts, reset
the control to the desired setting.
Bucket not installed properly. See
"Removing Collected Water".
Water in the bucket has reached its preset
level. Dehumidifier automatically turns
off when this occurs. Empty bucket and
return bucket to position.
Dehumidifier is not turned on. Turn unit on.
BUCKET FULL light is on. Remove buck-
et, empty water and re-install correctly.
Windows or doors near dehumidifier are
open to outdoors. Close all windows or
doors to outside.
Area to be dehumidified is too large.
Check with your dealer to see if capacity
is adequate.
Air movement through dehumidifier is
blocked. Grill may be dirty. Use brush at-
tachment of vacuum cleaner to clean grill.
See "Care and Cleaning". Dehumidifier
must be placed in a space that does not
restrict air flowing into the rear coil or out
of the front grill.
Dehumidifier has been installed or re-
started recently. The higher the moisture
in the room, the longer the dehumidifier
will operate.
Dehumidifier is in the CONTINUOUS
mode and will remain on in this mode, use
the humidity button or knob to set a RH%
higher level.