Setting The Table Capacity Mode; Rebooting The Device - HPE FlexNetwork 5510 HI Series Fundamentals Configuration Manual

Setting the table capacity mode

The switch supports multiple table capacity modes, as shown in
determines the capacities of the MAC address table, ARP or ND table, MPLS incoming label
mapping table, and VLAN mapping table.
Table 13 Table capacities in different table capacity modes
Table capacity mode
MAC address table capacity
ARP/ND table capacity
ILM table capacity
Incoming VLAN
capacity
Outgoing VLAN
capacity
To set the table capacity mode:
Step
1. Enter system view.
2. Set the
mode.

Rebooting the device

CAUTION:
• A device reboot might interrupt network services.
• To avoid configuration loss, use the save command to save the running configuration before a
reboot. For more information about the save command, see Fundamentals Command
Reference.
• Before a reboot, use the display startup and display boot-loader commands to verify that the
startup configuration file and startup software images are correctly specified. If a startup
configuration file or software image problem exists, the device cannot start up correctly. For more
information about the two display commands, see Fundamentals Command Reference.
The following device reboot methods are available:
•
Immediately reboot the device at the CLI.
•
Schedule a reboot at the CLI, so the device automatically reboots at the specified time or after
the specified period of time.
0
32K
16K ARP table
or 16K ND table
8K
mapping table
16K
mapping table
8K
Command
system-view
table capacity
switch-mode { 0 | 1 | 2 }
Table
1
64K
16K ARP table
or 8K ND table
4K
8K
4K
136
13. The table capacity mode
2
32K
16K ARP table or 8K ND table
when arp mode uni is not
configured
32K ARP table or 16K ND table
when arp mode
configured
4K
8K
4K
Remarks
N/A
The default table capacity mode is 0.
This setting takes effect after a
reboot. Before rebooting the switch,
make sure you know the possible
impact of the reboot on the network.
uni is