Equalizer Systems AUTO-LEVEL Operation And Warranty Manual page 5

During typical operation, the LED's on the bottom left hand corner of the keypad should NOT be illuminated. The
only LED that should light is the 'OPERATING' LED, which should flash during operation.
'POWER' LED ..........................................
'JACK' LED (4 each) .............................
'OPERATING' LED .................................
'LOW VOLTAGE' LED ..........................
'ENGAGE PARK BRAKE' LED...........
'IGNITION ON' LED ...............................
'EXCESS SLOPE' LED ..........................
Note:
If the LOW VOLTAGE, ENGAGE PARK BRAKE< IGNITION ON or EXCESS SLOPE
LED's illuminate, an "error" condition is present and must be corrected prior to operating
the jacks.
Keypad Indicator LED's
ON Red when power is ON
OFF when power is OFF
FLASH every 5 sec. In Sleep Mode
ON Red when jack(s) are deployed
OFF when jack(s) are stowed
ON Red w/ Auto Level or All Retract
OFF when keypad is idle or 'sleeping'
ON Red when voltage is below 10.5 volts dc
OFF when voltage is above 10.5 volts dc
ON Red when park brake is not set
OFF when park brake is set.
ON Red when ignition is in the ON position
OFF when ignition is OFF
ON Red following an Auto Level attempt, if
system cannot overcome slope
OFF when slope is not excessive
5.